How to extend PPH storage tank Service life of

The answer to the question of whether the service life of PPH storage tank can be extended is certainly yes. As for PPH storage tank, after our normal operation, the service life of this special equipment can be improved, just like the service life of good maintenance and overhaul at ordinary times. PPH mixing tank

1. The first is the requirements for installing PPH tank foundation. The platform degree can accept the corresponding pressure. If it is a steel structure, the gap should not be too large, and it should be covered with wood or iron plates. Check whether there are nails and other sharp objects on the plate to avoid damaging the water tank, and use concrete as the base. Smooth lubrication requirements. Ordinary mud can be used as substrate to increase the pressure of reinforcement.

2. When chemicals are stored in PPH storage tank, good drainage ditch and dilution device or leakage alarm device shall be set around the site after the storage tank arrives at the site.

3. During the installation of large volume storage tanks such as 20 cubic meters, 30 cubic meters and 50 cubic meters, special attention should be paid to safety, and cranes should be used as far as possible to enter the site.

4. After the PPH storage tank is installed, the sealing performance of the interface should be stopped in time before use. If conditions permit, the liquid can be added outside the interface to see if there is leakage. The storage tank contains chemical liquid, so take the initiative to conduct water seepage test to prevent the formation of a large amount of liquid loss, resulting in personnel, material and economic losses.

5. The pipe connected to the bottom flange of PPH storage tank shall be vertical to the barrel wall. It is recommended to use soft connection to avoid uneven shrinkage of the barrel wall after liquid filling, resulting in damage and leakage of the joint connection, thus damaging the joint flange, which will directly affect the overall life of the barrel in serious cases.

6. When the liquid inlet is higher from the tank bottom, the liquid inlet shall be bent towards the tank wall to let the liquid fall along the tank wall, so as to reduce the direct impact of liquid on the tank bottom.

7. When the mixer and other heavy auxiliary equipment are installed on the tank, or people are required to work on the top of the tank, but the top of the tank cannot bear the weight of people, please do other mixing channel steel supports, steel pipe ladders, fences, and pay attention to safe operation.

8. In the process of consumption or engineering operation, when the liquid level cannot be controlled in time, the level gauge or sensing device can be installed, and the tank manufacturer can contact to install an overflow port to prevent the liquid from overflowing the manhole, resulting in unnecessary loss and damage.

9. When the liquid flow in and out of the storage tank is large, technicians shall be arranged to install exhaust pipes with corresponding flow in time.

We may only know the two operation modes of repair and maintenance. I believe that after today's arrangement, you will also have more information to use, which will help us improve the service life of PPH tank and enable us to obtain more operational benefits.

PPH storage tank prompts that the above content is collected and sorted by the Internet, and the copyright belongs to the original author. If there is infringement, please contact us to delete the content, thank you!