The basic requirement for the installation of pph storage tank is that the platform should be placed horizontally and can withstand the corresponding pressure. If steel structure is used, the gap should not be too large, and wood or iron plate should be placed on it. And check whether there are nails and other sharp objects on the board to prevent damage to the water tank, or it can be made into a concrete base. It is required to be smooth and even. Ordinary mud floor can be used as underlay to increase strength and pressure.

When chemicals are stored in the pph tank (contact the manufacturer to customize the concentration tank first), after the tank arrives at the site, a drainage dilution or leakage alarm should be set up around the site.

Pay special attention to safety when installing large storage tanks of 20m3, 30m3 and 50m3. Try to use the crane to enter the site.

After the pph storage tank is installed, the sealing performance of the interface should be checked in time before use. If possible, add some liquid to the connector to see if it leaks. For the storage tank containing chemical liquid, try to leak water first to prevent the loss of a large amount of liquid and cause unnecessary loss of human, material and financial resources.

The pipe connecting the bottom of the pph storage tank with the flange shall be perpendicular to the barrel wall, and the soft connection shall be used to avoid the joint damage and leakage caused by the uneven expansion of the barrel. The wall surface after liquid filling will damage the connecting flange, which will directly affect the overall life of the storage tank in serious cases.

When the injection port rises from the tank bottom, it should bend to the tank wall to make the incoming liquid fall along the tank wall, so as to reduce the direct impact of liquid on the tank bottom.

If heavy auxiliary equipment such as mixer is installed on the water tank, or personnel are required to work on the top of the water tank and the top of the water tank cannot bear the weight of personnel, please prepare additional mixing channel steel support, steel pipe ladder and fence, and pay attention to the safety of operation.

If the liquid level cannot be observed in time during production or engineering operations, a level gauge or sensing device can be installed, and the tank factory can be contacted to install an overflow port to prevent liquid from overflowing from the container. Sand well and cause unnecessary losses and injuries.

When the inlet and outlet flow of the storage tank is large, technicians shall be arranged to install the exhaust pipe with corresponding flow in time.

PPH mixing tank Long service life. When changing the liquid, please refer to the chemical property table of pph, consider the liquid condition, whether it will react with the original stored liquid, and clean it in time.

The above content is collected and sorted by the Internet, and the copyright belongs to the original author. If there is infringement, please contact us to delete the content, thank you!